This may seem a pretty stupid question, but are the bolts that hold the clutch cover to the flywheel standard 5/16" x 24 UNF (1/2" AF)? That’s what it seems they ought to be, but new bolts I have aren’t keen to enter the threads. The bolts seems to be a tiny bit too large. Before I start ruining things, can you confirm that they are the standard bolt size. Thanks.
Mike
Hi Mike
They should be 5/16" UNC x 5/8 " Long . If you have difficulty finding some, I can pop some in the post for you.
Cheers
Nick
Hi Nick, thanks very much. I didn’t think they would be UNC - those are usually reserved for alloy castings. I don’t have any the right size and there are no outlets near here that sell imperial fasteners, so if you can send me six I would be grateful. I will PM you my address details. How much would you like for them?
Mike
HI Mike
You will find UNC threads used on all the aluminium castings and cast iron in the Elan
Yes I would expect UNC on cast aluminium and iron. But isn’t the flywheel steel?
Mike
standard flywheel cast iron I believe like the crank
cheers
Rohan
As a rule of thumb if it screws into something - coarse. If it has a nut - fine.
There are many reasons and so many exceptions - Brake fittings for example are UNF into cast iron and aluminium.
This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.