I?m now about to fit new GAZ rear dampers to my Elan S4 and notice that the dampers are slightly shorter than the removed items.
There is a spacer provided which goes under the bottom of the GAZ unit to allow the top retaining but to fully clamp it into the tube now, suppose I don?t fit the lower spacer but make up a top spacer to do the same job? Will this give me the required droop restriction should I fit solid drive shafts at a later date? The spacer and slightly shorter damper travel will amount to about 20mm. How much does one need to shorten the droop for certain shaft kits?
Julian.