Parts I could make in my CNC shop

I have seemed to have taken over a thread in the +2 forum. So I will start it here.
I own a CNC machine shop and I have been making special parts for British cars for a couple of years now and I am getting more and more busy on this side. Alredy making aluminum pulley’s for MG and Triumph should I be looking at parts for Lotus as well? My parts have been selling world wide not to just North America.
Let me know of any ideas you might have? I will then look into the possibility of these projects.
Thanks for your help.

Here are some suggestions for the Europa that always come up as hard to procure:

  • Stub axles in two different varieties
  • Rear hubs
  • Hardened spacers to separate the two bearings in the hub carrier. Not hard to make but the group would like a reliable U.S. Source for a quality part. I’ll guess you are in the U.S.
  • For the Renault engine, there’s a gear drive takeoff from the camshaft that drives the oil pump and distributor. You mess it up when you assemble the head without the right tools. A Europa lister borrowed the messed up one I had from an engine I bought. His shop said too hard, but some of us would like a source of replacements. Not sure there’s a big market in this one.

– Doug Nicholls, 54/1822 Ma~